FydeOS Display Issues Raspberry Pi CM5

:pushpin:Question Description

Have you searched the community for related issues? Yes

  • No similar issues found.

Please describe the problem you’ve encountered in detail:

  • Description: Just trying to do a basic install and use of FydeOS but the Display is set at 4K at 30 Hz. If I try to adjust to 1080P at 60 Hz the Pi automatically crashes and reboots and goes back to the previous resolution.

I’ve even adjusted the config.txt to force 1080P at 60 Hz and the resolution does get adjusted but the refresh is still stuck at 30 Hz.

Then only unique thing I am finding in my situation is I am using a Compute Module (CM5) along with this Waveshare board: Nano Base Board (B) for Raspberry Pi Compute Module 5, Same Size As The CM5. It does say HDMI0 so assuming no issues with displaying at 60 Hz.


:computer:System & Device Information

  • Hardware & System Configuration:

    • Processor: CM5
    • Graphics Card(Please specify if there’s a discrete graphics card): CM5
    • RAM: 16 GB
    • FydeOS Version: Latest
  • Relevant System Logs:

    • Open the Chromium browser and enter /var/log/messages to retrieve logs.
    • Log Details:

Note: If you’ve lost your FydeOS subscription, please refer to this FAQ for assistance.


does fydeos support cm5 officially ?i’m confused :sweat_smile:

Good question!

I am actually chatting with Waveshare Support about this as well. They are going to test out their board and CM5 with FydeOS to rule out it’s not just my TV or setup. But I confirmed on the past I had no issues with Raspberry Pi 5 itself and Khadas Edge 2 running Fyde at 60 Hz refresh.